CCNP 300-101 5/31 pass . Here has some new questions.
本帖最后由 cupidexam 于 2018-6-1 01:04 编辑Hi, I passed the 300-101 exam yesterday, and much thanks and share experiences with you here.
There were totally 53 questions.
※Choice Question:
Most of questions were included in 5/09 materials , and besides, some new questions I met were listed as below:
New Q:
The Neighbor Discovery protocol in IPv6 replaces which protocol in IPv4?
A. ARP
B. IGMP
C. ICMP
D. CDP
My answer: A
----------------------------------------------
New Q:
A network engineer executes the command "show ip eigrp vrf purple topology".
Which type of information is displayed as a result?
A. routes for a global routing table.
B. route successors for a specific routing table.
C. active neighbors for a global routing table.
D. updates that were sent for a specific routing table.
My answer: B
Note: you could type this command "show ip eigrp vrf * topology" in one router configurated
in the 5/09 lab. Q4 sim: "EIGRP stub". You will know what the command means.
----------------------------------------------
New Q:
What is the function of the "snmp-server enable traps" and
"snmp-server host 192.168.1.3 trap version 1c public" commands?
A. to allow private communications between the router and the host.
B. to collect information about the system on a network management server.
C. to disable all SNMP informs that are on the system
D. to allow only 192.168.1.3 to access the system using the community-string public.
My answer: D
----------------------------------------------
New Q:
See the exhibit.
http://www.vceguide.com/wp-content/uploads/2016/12/300-101-implementing-cisco-ip-routing-route-v2-0_img_130.jpg
Which option prevents routing updates from being sent to the DHCP router, while still allowing
routing update messages to flow to the Internet router and the distribution switches?
A. ACL condition 1 (blah hlah blah...)
B. ACL condition 2 (blah hlah blah...)
C. ACL condition 3 (blah hlah blah...)
D. ACL condition 4 (blah hlah blah...)
----------------------------------------------
New Q:
Belong to a TCP/UDP port blocking problem.
This new quesion tells you that one iOS syslog server could send messages to a windows log server
if something happen. However, some events occurred and windows log server doesn't receive any log.
What's the root cause in the iOS syslog server?
A. Either ACL ........or block TCP 514
B. Either ACL ........or block UDP 514
C. Either ACL ........or block UDP 512
D. Either ACL ........or block .............
My answer: B
Here link for your reference.http://www.ciscopress.com/articles/article.asp?p=426638
※Drag and drop
About this section, just study the 5/09 material is enough.
Q107 : DHCP Relay Information (Check, Policy...)has some new descriptions on the right.
※Lab. Question
EIGRP case, EIGRP stub, and Route Map.
Good luck. :victory: 感謝大大分享 That was a lot of information, THX. {:6_268:} congratulation!! also thanks a lot for the new questions. 感謝大大分享 thans a lot ,you give us good advice and materials.Best wish to you to pass rest examation Appreciated for your share the information and congratulations! 感謝分享 感謝分享 thanks 强! {:6_290:} 感谢分享 Congratulations ! Thanks a lot !