CCNA LAB 78: Configuring the OSPF Passive Interface Manually
本帖最后由 小乔 于 2022-12-28 10:43 编辑Lab Objective:
The objective of this lab exercise is for you to learn and understand how to manually configure the OSPF passive interface. We will repeat the previous lab but then make one of the interfaces passive. This of course will bring down the OSPF connection.
Lab Purpose:
Manually configuring the OSPF passive interface is a fundamental skill.
Certification Level:
This lab is suitable for CCENT certification exam preparation.
Lab Difficulty:
This lab has a difficulty rating of 5/10.
Readiness Assessment:
When you are ready for your certification exam, you should complete this lab in no more than 10 minutes.
Lab Topology:
Please use the following topology to complete this lab exercise:
Task 1:
Configure hostnames on routers R1 and R3 as illustrated in the topology.
Task 2:
Configure R1 S0/0, which is a DCE, to provide a clock rate of 768 Kbps to R3. Configure the IP addresses on the Serial interfaces of R1 and R3 as illustrated in the topology.
Task 3:
Enable OSPF in area 0 between R1 and R3. For R1, use OSPF process ID 1. For R3, use OSPF process ID 3. Verify that your OSPF adjacency has formed between R1 and R3. Make a mental note of the OSPF router ID being used at this time after the adjacency between R1 and R3 has been established.
Task 4:
Manually configure OSPF router ID 1.1.1.1 on R1 and 3.3.3.3 on R3. Reset the OSPF process ID on R1 and R3 by issuing the clear ip ospf process command. Verify that the OSPF adjacency has been re-established between R1 and R3. Verify that the OSPF neighbor IP addresses are now showing as the manually configured router IDs instead of the physical interface IP addresses.
Task 5:
Set S0/0 on R3 as a passive interface.
Configuration and Verification
Task 1:
See previous lab.
Task 2:
See previous lab.
Task 3:
See previous lab.
Task 4:
Task 5
来源: CCNA LAB 69: Assigning Multiple Instances to a VLAN Simultaneously
来源: CCNA LAB 70: Configuring Spanning Tree Protocol for Access Ports (PortFast)
来源: CCNA LAB 71: Enabling Rapid Per-VLAN Spanning Tree
来源: CCNA LAB 72: Configure, Verify, and Troubleshoot EtherChannels (Static/PAgP/L...
来源: CCNA LAB 73: Configuring 802.1X Security
来源: CCNA LAB 74: Configuring DHCP Snooping
来源: CCNA LAB75: Configuring OSPF on Point-to-Point Networks
来源: CCNA LAB76: Configuring OSPF on Broadcast Networks
来源: CCNA LAB 77: Configuring the OSPF Router ID Manually
{:6_267:}{:6_267:}{:6_267:} 谢谢楼主分享！ 看看，谢谢！！！ 谢谢分享 {:6_267:}{:6_267:}{:6_267:}{:6_267:}
页:
[1]