CCNA LAB 79: Configuring Single-Area OSPFv3
本帖最后由 小乔 于 2022-12-28 10:48 编辑Lab Objective:
The objective of this lab exercise is for you to learn and understand how to manually configure OSPFv3, which is a core ICND2 and CCNA topic.
Lab Purpose:
Manually configure IPv6 interface addressing and then configure a Single-Area OSPFv3 connection.
Certification Level:
This lab is suitable for ICND2 and CCNA certification exam preparation.
Lab Difficulty:
This lab has a difficulty rating of 7/10.
Readiness Assessment:
When you are ready for your certification exam, you should complete this lab in no more than 10 minutes.
Lab Topology:
Please use the following topology to complete this lab exercise:
Task 1:
Configure hostnames on routers R1 and R3 as illustrated in the topology.
Task 2:
Configure the IPv6 addresses on the FastEthernet interfaces of R1 and R3 as illustrated in the topology.
Task 3:
Enable OSPF in area 0 between R1 and R3. For R1, use OSPF process ID 1. For R3, use OSPF process ID 3. Configure router ID 1.1.1.1 for R1 and 3.3.3.3 for R3.
Task 4:
Ping across the link and then use the relevant show commands to verify your configurations.
Configuration and Verification
Task 1:
For reference information on configuring hostnames, please refer to earlier labs.
Task 2:
Task 3:
Task 4:
来源: CCNA LAB 69: Assigning Multiple Instances to a VLAN Simultaneously
来源: CCNA LAB 70: Configuring Spanning Tree Protocol for Access Ports (PortFast)
来源: CCNA LAB 71: Enabling Rapid Per-VLAN Spanning Tree
来源: CCNA LAB 72: Configure, Verify, and Troubleshoot EtherChannels (Static/PAgP/L...
来源: CCNA LAB 73: Configuring 802.1X Security
来源: CCNA LAB 74: Configuring DHCP Snooping
来源: CCNA LAB75: Configuring OSPF on Point-to-Point Networks
来源: CCNA LAB76: Configuring OSPF on Broadcast Networks
来源: CCNA LAB 77: Configuring the OSPF Router ID Manually
来源: CCNA LAB 78: Configuring the OSPF Passive Interface Manually {:6_267:}{:6_267:}{:6_267:}{:6_267:}
页:
[1]